Effekta ES2200 - Page 66

Photovoltaic Solar Inverter Series ES
Status Diagnosis and Troubleshooting
ES series
66
LCD
display
Description
Explanation
Troubleshooting
Er19
DC_BUS
discharge failure
The capacitors of the DC bus
cannot be discharged
correctly.
1. Disconnect all
PV (+)- or PV (-)
connections.
2. Wait a few seconds.
3. After the LCD
display goes out,
restore all the
connections and
check again.
4. If the error occurs
again, please
contact your dealer.
Er22
Output Relay fail
Malfunction on the output relay
of the photovoltaic solar
inverter.
Er24
Output current
sense fail
Error in the output current
reading.
Er25
BOOSTER_A
over-current
The current in the DC mains is
higher than expected.
Er26
BOOSTER_B
over-current
Er29
PV inverter output
DC current over
spec.
DC current at output of
photovoltaic solar inverter is
too high.
Er06
EPO
The photovoltaic solar inverter
is in emergency power off
mode.
5. Detach the
connection at the
EPO connection.
6. If the error occurs
again, please
contact your dealer.
Er09
PV inverter
over-current
Over-current on the AC side.
The current in the AC mains is
higher than expected.
7. Turn off the AC
current switch, check
the peripheral AC
current system
configurations and
the mains
conditions.
8. If the error occurs
again, please
contact your dealer.
Er11
PV inverter
over-load
Over-load on the AC side.
The mains load in the AC
mains is higher than
expected.
Er13
PV inverter
short-circuit
Short circuit on the AC side.
Er14
PV inverter
PLL failure
The photovoltaic solar inverter
is not in phase with the mains
electricity.