Driving your scooter
Safety check before use
When driving your eFOLDi, choose a route with good road condi-
tions. The eFOLDi is designed to drive on smooth even surfaces.
Unevenly paved roads or paths, potholes and other hazards will
reduce the life of any scooter and may aect your safety. Do not
drive on steep roads or excessively cambered roads. The amount
of charge remaining in the battery immediately before commenc-
ing any slope upward will be crucial to the climbing ability. Any
deviation from level/horizontal surfaces should not exceed a gra-
dient of 1:6 (9.5 degrees). For any climbing there are many factors
that need to be considered these are: the tyre pressure and con-
dition, the surface condition (if wet, icy or slippery, and this in-
cludes leaf cover and/or other debris, we advise against driving
the slope), battery charge and the weight of the user, all of these
will aect performance.
1 Manual hand brake lever 2 Brake lock (Parking lock)
3 Brake adjuster 4 Speed / Reverse switch
5 Twist throttle 6 Battery voltage display
7 Hazard light switch 8 Turning indicator
9 Ignition Key 10 Headlight switch
11 Turning indicator switch 12 Horn
Table 1: Model: Explorer (MK1.5) Control bar
• Ignition switch (9) To switch on the scooter, the key will need to be
turned clockwise from the 9 to 11 o’clock position.
• Hazard light (7) With the ignition on, a continual beeper sounds
when operated by pressing the triangular button.
• Brake lever (1) When the brake lever is applied, power to the motor
is cut o and brake lights illuminate.
Rev. A, English 25
To Next Page
Loading...
