eFOLDi Lite - Folding Instructions; Folding: Suitcase to Scooter Mode

When unfolding/folding your eFOLDi Lite
ensure:
• The scooter is positioned on a level oor or ground.
• Main switch is switched o.
• All latch pins are properly secured in place, as stated on
the instructions and shown on the illustrations.
Safety check before use:
It is highly recommended that you perform a safety check be-
fore each use to make sure your eFOLDi operates smoothly and
safely.
• Check for correct tyre ination. Maintain but do not exceed
the manufacturer recommended tyre pressure rating indi-
cated on the pneumatic tyres;
• Check all electrical connections. Make sure they are se-
cure and not corroded;
• Check and test the brake system;
• Check frequently for any loose fasteners, xings and other
components.
EMC WARNING STATEMENT
The interference from radio wave sources such as radio stations,
TV stations, two way radios or cellular phones can cause the mo-
bility scooter to release its brakes, move by itself, or move in unin-
tended directions. It can also permanently damage the mobility
scooter control system.
The intensity of the interfering EM energy can be measured in
volts per meter (V/m). Each mobility scooter can resist EMI up
to a certain intensity. This is called the "EMI immunity level". The
higher the EMI immunity level, the greater the protection from
EMI. Currently the eFOLDi scooter has an immunity level of at least
20V/m, which provides useful protection from the common sources
of EMI.
The sources of radiated EMI can be broadly classied into three
Page 10