Charger and Charging
Precaution for use and handling charger
Use only the charger originally supplied with your new eFOLDi
or replacement charger supplied by SunTech UK Ltd for the use
with the eFOLDi. The use of a non-approved charger will invali-
date any warranty and may cause serious damage to the battery
and/or your eFOLDi. The charger should not be used with or for
other devices as damage caused to the charger and/or any other
device by doing so will not be covered by our warranty.
It is highly recommended to ensure the charger is placed only on
heat resistant surfaces and nothing which could contribute to a
re (e.g. carpet, oorboards, wood, laminate or plastic worktops
and so on) - the charger will heat up during a normal charging
cycle, as will the battery.
Do not leave the battery on charge for more than 24 hours, as this
will reduce the life and performance of the battery.
Charging notes for international travellers
For the benet of international travellers, your approved eFOLDi
charger can be used with any mains voltage supply from 100 to
240 Volts, with a suitable travel adaptor.
Using the charger
After the easy removal of the battery it can be charged up by
plugging into the socket.
*Before obtaining an alternative cable, it is recommended you ex-
amine your eFOLDi charger to determine which type of plug it re-
quires - it will be either a two -pin ‘gure of 8’ (IEC60320-1 C7), or
a three-pin similar to a kettle (IEC60320-1 C13).
Page 22
To Next Page
Loading...
