EG4 LIFEPOWER4 48V User Manual

UPDATE STEPS:
1. Begin by powering o the batteries receiving the update via the circuit breaker on the front of
the unit.
2. Adjust the battery DIP switches to address 0 (all DIPs down, see image below).
3. Remove all inter-battery communication cables from the batteries in parallel and set one to
the side for the update.
DIP switch address 0
Battery circuit breakers OFF
NOTE: Ensure all communication cables, aside from the update cable, are disconnected from the
battery receiving the update!
Battery parallel communication cables

EG4 LIFEPOWER4 48V Specifications

General

Capacity	100Ah
Chemistry	LiFePO4
Output Voltage	48V
Communication Interface	RS485, CAN
Protection Features	High temperature, Low temperature
Cycle Life	>6000 cycles @ 80% DOD