5
6) Stop the engine and remove battery and push button.
7) Reconnect all wires.
8) Start engine and check the output voltage.
●
●●
●
NOTE
To take flash exciting without engine running, keep the button on a pushed condition to
close the flash exciting circuit for 30sec.
7.2. AUTOMATIC FILED FLASH EXCITING
Whenever start generator set, to avoid no output voltage. It is recommended to take automatic
field flash exciting by using the generator control sequence as below drawing.
8. PARALLE OPERATION
AVR 125 are not designed for parallel operation ,but connecting a external variable resistance with a
toggle switch as below drawing, in series with one line of two input sensing lines to the regulator, the
the regulator can run in droop performance for inductive load.
To Next Page
Loading...