Need help?Do you have a question about the Eggtimer Rocketry TX Board Rev B4d and is the answer not in the manual?
General| Brand | Eggtimer Rocketry |
|---|---|
| Model | TX Board Rev B4d |
| Category | GPS |
| Language | English |
TX and RX boards using 900 MHz band with 100 mW output power.
Discusses range, signal loss during boost, and signal recovery.
Board dimensions and importance of keeping metal away from the antenna.
Use nylon or plastic screws near the antenna; avoid metal screws.
Minimum 200 mAH capacity recommended for 3+ hours of operation.
Simple button press activates GPS and transmission; disconnect battery to power off.
Driver installation for the Prolific PL2303HX USB-Serial chip.
Configure 9600 baud, 8 bits, no parity, 1 stop bit, no flow control.
Setting waypoints and home location within the app.
Manually entering latitude and longitude for the landing site.
GPS module, transmitter module, and antenna options for the TX board.
Receiver module and antenna options for the RX board.
Key tips for TX installation, battery requirements, and mounting.
To Next Page