CULTIVATOR ATTACHMENT — CTA950012
TROUBLE SHOOTING
PROBLEM
CAUSE SOLUTION
Cultivator fails to start.
◾ The battery pack is not properly attached
to the power head.
◾ Attach the battery pack to the power
head.
◾ No electrical contact between the power
head and the battery pack.
◾ Remove battery, check contacts and
reinstall the battery pack so that it
snaps into place.
◾ The battery pack is depleted. ◾ Charge the battery pack with an EGO
charger listed in this manual.
◾ The lock-off lever and trigger are not
depressed simultaneously.
◾ Press the lock-off lever and hold it,
then depress the trigger to turn on
the unit.
Cultivator stops while
tilling.
◾ The motor is overloaded. ◾ The motor will recover when the load
is removed. For continuous work,
decrease the load on the cultivator
and avoid deep tilling; instead, make
progressively deeper cuts.
◾ The battery pack is too hot. ◾ Allow the battery pack or to cool until
the its temperature drops below 67°C.
◾ The blades are jammed. ◾ Remove the battery from the power
head, manually rotate the blades back
and forth to remove the stones or
other obstacles between the blades or
between the blade and the gear box.
◾ The battery pack is disconnected from
the tool
◾ Re-install the battery pack.
◾ The battery pack is depleted ◾ Charge the battery pack with an EGO
charger listed in this manual.
To Next Page
Loading...