Ego Power+ LM2160SP - CUTTING-HEIGHT ADJUSTMENT; Adjusting the Mowers Cutting Height; ATTACHING THE PHONE HOLDER ASSEMBLY; Installing the Phone Holder

56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2160SP/LM2160SP-FC32
CUTTING-HEIGHT ADJUSTMENT
(Fig. 23)
WARNING:
Do not at any time
make any adjustment to the lawn mower
without first stopping the motor, removing
the battery pack, and waiting until the
blade has stopped rotating.
WARNING:
Keep your feet away
from the deck when adjusting its height.
The mower can be set to 8 cutting heights between 1" (25mm) and 4" (105mm).
Choose the proper cutting height according to the type and condition of the grass to be
cut.
1. Use one hand to hold the aluminum side rails for stability and use the other hand
to move the spring-loaded cutting-height-adjustment lever outwards from the
slots in the cutting-height indication plate.
2. Move the cutting-height-adjustment lever toward the back of the mower for
higher grass-cutting height; move it toward the front of the mower for lower
grass-cutting height.
3. Once arriving at the desired cutting-height position, engage the spring-loaded
cutting-height-adjustment lever back into the slot.
ATTTACHING THE PHONE HOLDER
ASSEMBLY (Fig. 24)
1. Insert the lower two tabs on the
phone holder assembly into the
lower holes in the switch box cover,
then insert the upper two tabs into
the upper holes.
2. Push the phone holder assembly
downward against the switch box
cover until it engages with an audible “click”.
A
C
B
24
Switch Box Cover
Holes
Tabs
CLICK
B
A
8
3
2
1
7
6
23
Cutting-Height Adjustment Lever
Cutting-Height
Indication Plate