56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2160SP/LM2160SP-FC56
PROBLEM CAUSE SOLUTION
Short runtime of
the mower with
included battery.
◾
Grass conditions and cutting-
height setting will greatly affect
the battery run time. The claimed
run time is based on a light load
condition.
◾
The blade speed mode is not set
properly.
◾
Raise the blade height and slow
your pace to reduce the cutting
load.
◾
Select a slower blade speed
mode.
The mower
does not mulch
properly.
◾
Wet grass clippings are sticking
to the underside of the deck.
◾
The mower is set to cut too much
grass at once.
◾
The blade speed mode is not set
properly.
◾
Wait until the grass dries before
mowing.
◾
Raise the deck to a higher
cutting-height setting.
◾
Select a faster blade speed
mode.
The mower
stops while
mowing.
◾
The battery pack is depleted.
◾
Mower is in overload condition.
◾
Mower deck is clogged with
grass and debris.
◾
The battery pack or mower
circuitry is too hot (The power
indicator on the mower emits an
orange light for 10 seconds).
◾
The side rail is retracted a little
by the pushing force applying on
the handle.
◾
The blade speed mode is not set
properly.
◾
Charge the battery pack.
◾
Raise the cutting height or slow
down the mowing.
◾
Unclog the mower deck. Raise
the cutting height and/or cut a
narrower swath.
◾
Allow the battery pack or mower
to cool until the temperature
drops below 152°F (67°C).
◾
Unlock the clamps. Fully extend
the side rails and lock the
clamps again.
◾
Select the blade speed to a
lower setting.
To Next Page
Loading...
