Ego Power+ SNT2800

To Next Page

To Previous Page

56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2800/SNT2800-FC 17

PACKING LIST

PART NAME QUANTITY

Snow Blower 1

Handle Assembly 1

Snow-Discharge Chute Assembly 1

Knob & Bolt Set 6

Chute Cleaning Tool 1

Shear Pin 2

Operator’s Manual 1

INSTALLING THE HANDLE

ASSEMBLY (Fig. 2)

NOTICE:

The handle assembly requires

assembly before operating the snow

blower (Fig. 2a).

NOTICE: Check and make sure the wire

cables are not twisted before installing

the handle assembly. Otherwise, the

wire cables may be damaged due to

overstretching.

Lift the handle assembly, align the holes

in the side rails with the holes in the rear

handle, select the preferred handle height,

then secure the handle assembly with

4 bolts and knobs (Fig. 2b). Please see

section “HANDLE HEIGHT ADJUSTMENT”

for detailed adjustment instructions.

Rear Handle

Handle

Assembly

Bolt

Side

Rails

Knob

Ego Power+ SNT2800 - Page 17