Ego Power+ SNT2800 - Page 18

56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2800/SNT2800-FC18
INSTALLING THE SNOW-
DISCHARGE CHUTE ASSEMBLY
(Fig. 3)
WARNING:
Never operate the
snow blower without the complete
snow-discharge chute in place.
1. Lift the snow-discharge chute assembly
and align the outer support pole with
the inner support pole (Fig. 3a).
2. Slide the outer support pole down
until the snow-discharge chute is fully
seated on the base.
3. Secure the snow-discharge chute
assembly with two knobs and bolts
(Fig. 3b).
3b
Knobs & Bolts
3a
Outer Support Pole
Inner
Support
Pole
Snow-
Discharge
Chute
Base