EGO 55 Series - Table of Contents

product operating instruction
E.G.O. Germany (E.G.O. Elektro-Gerätebau GmbH)
document id.: 90.60145.653-001-02-A / state: 230 - released
designation: Thermostats 55.xxxxx.xxx / 56.xxxxx.xxx
page
3
of
19
Table of contents
1 About these operating instructions ......................................................................... 5
1.1 Validity ........................................................................................................................... 5
1.2 Handling of these operating instructions ....................................................................... 5
1.3 Revisions ....................................................................................................................... 5
1.4 Other applicable documents .......................................................................................... 5
1.5 Symbols and markings .................................................................................................. 6
2 Safety ......................................................................................................................... 7
2.1 Intended use .................................................................................................................. 7
2.2 Staff qualification ........................................................................................................... 7
2.3 Residual risks................................................................................................................. 8
2.3.1 Sharp edges ..................................................................................................... 8
2.3.2 Sensor tip ......................................................................................................... 8
2.3.3 Live parts .......................................................................................................... 8
2.3.4 Deformation ...................................................................................................... 9
2.3.5 Ingress of foreign parts ..................................................................................... 9
2.3.6 Too high force when attaching or removing the receptacle ............................. 9
2.3.7 Too high force when putting on the knob ......................................................... 9
2.3.8 Incorrectly selected, assembled or reused stuffing box sets ........................... 9
2.3.9 Leaking substances ........................................................................................ 10
2.3.10 Unsuitable material pairings and aggressive substances .............................. 10
2.3.11 Overheating .................................................................................................... 10
2.3.12 Failing below the minimum switching power .................................................. 11
2.3.13 Exceeding the maximum number of switching cycles .................................... 11
2.3.14 Aging (thermal cut-outs and temperature limiters) ......................................... 11
2.3.15 Deviating switching temperatures and hysteresis .......................................... 11
2.3.16 Uneven heat distribution on the sensor .......................................................... 11
2.3.17 Temperatures too high or too low ................................................................... 12
2.3.18 Too high pressure on the sensor .................................................................... 12
2.3.19 Changes and readjustments on the thermostat ............................................. 12
2.3.20 Blocking of the switching mechanism............................................................. 12
3 Transport and storage ............................................................................................ 13
3.1 Transport ...................................................................................................................... 13
3.2 Storage ........................................................................................................................ 13
4 Installation and Commissioning ............................................................................ 14
document id.: 90.60145.653-001-02-A / state: 230 - released
view date: 2023-05-22 12:49:50 / user: SCHLAGET
item id.: 55.32519.440-00/69A / SAP material state: 1A