What to do if EGO EA0800 is leaving an uneven edge?
If your EGO Edger is leaving an uneven edge, it could be due to: * Grass or soil being too wet. Avoid edging in wet conditions. * A clogged blade guard. Stop the motor, remove the battery pack, and clear any debris from the blade guard.
How to fix an uneven edge with my EGO Edger?
If you're getting an uneven edge with your EGO Edger, here's what to check: * Avoid edging when the grass or soil is too wet. * Stop the motor, remove the battery pack, and clear any debris from the blade guard if it's clogged.
How to fix an EGO EA0800 Edger when the motor fails to start?
If the motor of your EGO Edger fails to start, consider the following: * Ensure the battery pack is correctly attached to the power head. Attach the battery pack securely. * Check for electrical contact issues between the power head and the battery pack. Remove the battery, inspect the contacts, and reinstall the battery pack until it clicks into place. * Verify that the battery pack is charged. Charge the battery pack with EGO chargers listed in this manual. * Make sure you are pressing the lock-off lever and trigger simultaneously. Press down and hold the lock-off button, then depress the trigger to start the edger.
Why does my EGO EA0800 Edger power head stop during operation?
The EGO Edger power head might stop during operation due to several reasons: * The motor may be overloaded. The motor will recover once the load is removed; decrease the load for continuous use. * The battery pack or power head may be too hot. Allow them to cool down until the temperature is below 152°F (67°C). * The battery pack might be disconnected. Re-install the battery pack. * The battery pack could be depleted. Charge the battery pack using EGO chargers listed in this manual.
What to do if my EGO EA0800 Edger stops during operation?
If your EGO Edger stops during operation, it could be due to several reasons. The motor might be overloaded; it will recover once the load is removed, so try decreasing the load. Alternatively, the battery pack or power head may be too hot, in which case you should allow them to cool down below 67°C. Also, check if the battery pack is disconnected and reinstall it if necessary. Finally, the battery pack might be depleted, so charge it using EGO chargers listed in this manual.
Why won't my EGO Edger motor start?
If the motor of your EGO Edger fails to start, there are several potential causes. First, ensure the battery pack is correctly attached to the power head. If it is, remove the battery and check for any obstructions, then reinstall it until it snaps into place. The battery pack might also be depleted, so charge it with EGO chargers listed in this manual. Finally, make sure you are pressing down the lock-off button and holding it while depressing the trigger simultaneously to turn on the power head.
General| Adjustable Cutting Depth | Yes |
|---|---|
| Motor | Brushless |
| Cutting Width | 8 inches |
| Weight | 12.8 lbs |
| Battery Compatibility | EGO 56V ARC Lithium-ion |
| Run Time | Up to 60 minutes |
| Power Source | Battery |
| Warranty | 5-year limited |
To Next Page
