EARTH/ICE AUGER — EG0800/EG0800-FC/IG0800/IG0800-FC30
REPLACING THE ICE BLADES
(Fig. 9)
If ice auger jumps on the ice or cuts
slowly through the ice when drilling
ice holes, ice blades may need to be
replaced.
Required tools: 6 mm Allen key
(provided), 3 mm Allen key (not provided)
1. Remove the battery pack from the
auger, and remove the ice auger bit
from the drive shaft of the power
head by using the 6 mm Allen key
to loosen and remove the locking
screw.
2. Wear protective gloves and remove
the ice blade guard (Fig. 9a).
3. Using the 3 mm Allen key, loosen
and remove the screws and ice
blades from the ice auger bit
(Fig. 9b).
4. Replace with new blades and tighten them securely.
5. Install the blade guard.
STORING THE MACHINE
1. Remove the battery pack from the auger.
2. Remove the auger bit from the drive shaft of the power head.
3. Clean the auger thoroughly before storing it.
4. Install the blade guard onto the ice auger bit.
5. Store the auger in a dry, well-ventilated area, locked-up or up high, out of the
reach of children. Do not store the auger on or adjacent to fertilizers, gasoline, or
other chemicals.
9a
Ice Blades
Blade Guard
9b
Screw
Ice Blade
To Next Page
Loading...
Need help?
General
