1. Release switches and remove the battery pack from the mower.
2. While wearing protective gloves, turn the mower on its side (Fig. 1).
3. Place a metal rod (e.g., a thick bit) with a diameter less than 11mm into the fixing hole to act as a
stabilizer and place another metal rod (e.g., a thin bit) with a diameter less than 6.35 mm into the
holes (the through holes in the fan with the holes in the blade) to act as another stabilizer (Fig. 2).
1. Blade Removal
3
Another
Stabilizer
Stabilizer
2
LM2010E Lawn Mower
1
Fixing hole
To Next Page
Loading...
