EGO LM2010E - Page 9

6. Turn the blade by hand to align the holes in blade with the through holes in the inner flange(Fig. 1).
7. Place a metal rod (e.g. a thin bit) with a diameter less than 6.35mm into the aligning holes to act as
a stabilizer. Place another metal rod (e.g. a thick bit) with a diameter less than 11mm into the fixing
hole on the deck to act as another stabilizer(Fig. 2).
8. Use a torque wrench(S=14mm) to tighten the bolt clockwise. The recommended torque for the
blade bolt is 50±5N·m.
2. Blade Installation
9
Stabilizer 2
Stabilizer 1
Tighten
2
Align the hole
1
THE END
LM2010E Lawn Mower