EGO LM2200SP User Manual

56-VOLT LITHIUM-ION CORDLESS 22” LAWN MOWER — LM2200SP/LM2200SP-FC 49
PROBLEM CAUSE SOLUTION
There is
excessive
vibration.
◾
The cutting blade set is loose.
◾
Tighten the shaft bolt.
◾
The cutting blade set is
unbalanced.
◾
Balance the blade set following
the“SHARPENING THE
BLADES”.
◾
The cutting blade(s) is bent.
◾
Replace the blade(s).
◾
The motor shaft is bent.
◾
Contact EGO Customer Service.
◾
The mower is set to cut too much
grass at once.
◾
Raise the deck to a higher
cutting-height setting.
◾
The blade speed mode is not set
properly.
◾
Select the blade speed to a
lower setting.
Mower is
difficult to be
pulled back
after the self
propel is turned
off.
◾
The wheels are temporarily
locked.
◾
Simply push ahead slightly or
raise the rear wheels and then
move the mower as desired.
Mower is
difficult to
maneuver when
mowing around
an object or
mowing back
and forth with
self-propel
turned on.
◾
The wheels are temporarily
locked.
◾
Turn off the self propel.
The motor
works but
the blade set
doesn’t cut the
grass.
◾
The shaft bolt is not tightened to
the required torque.
◾
Re-tighten the shaft bolt. The
recommended torque is 36-43
ft-lb (50-60 Nm).

EGO LM2200SP Specifications

General

Brand	EGO
Model	LM2200SP
Category	Lawn Mower
Language	English