EDGER ATTACHMENT—EA0800 23
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
Motor fails to start.
The battery pack is not
attached to the power
head.
Attach the battery pack to the power
head.
No electrical contact
between the power head
and the battery pack.
Remove the battery, check contacts
and reinstall the battery pack until it
snaps into place.
The battery pack is
depleted.
Charge the battery pack with EGO
chargers listed in this manual.
The lock-off lever and
trigger are not depressed
simultaneously.
Press down the lock-off button and
hold it, then depress the trigger to
turn on the edger.
Power head stops
during operation.
The motor is overloaded.
The motor will recover when the
load is removed. For continuous
working, decrease the load on the
power head.
The battery pack or the
power head is too hot.
Allow the battery pack or power
head to cool until the temperature
drops below 152°F (67°C).
The battery pack is
disconnected from the tool.
Re-install the battery pack.
The battery pack is
depleted.
Charge the battery pack with EGO
chargers listed in this manual.
Uneven edge.
Grass or soil edged is
too wet.
Avoid edging in wet soil or wet
grass.
Blade guard is clogged.
Stop the motor, remove the
battery pack, and remove debris
from the blade guard.
To Next Page
Loading...
Need help?
General
