EGO POWER + SNT2100 User Manual

56V LITHIUM-ION CORDLESS BRUSHLESS SNOW BLOWER — SNT210014
INSTALLING THE CHUTE
1. Loosen the two bolts in the chute
housing with the supplied hex
wrench and remove them from the
chute housing (Fig. 7).
2. Align the grooves of the chute with
the slot on the chute housing and then
push the chute into place (Fig. 8).
3. Use the hex wrench to lock the chute
in place with the two bolts (Fig. 9).
WARNING:
Using the chute-
rotation handle located at the operator’s
position, make sure that the chute rotates
properly with the discharge opening never
crossing operator controls.
WARNING:
Never operate snow
blower without having full discharge
chute in place.
7
Chute
Housing
8
Slot on
the Chute
Housing
Groove of the Chute
9

EGO POWER + SNT2100 Specifications

General

Brand	EGO
Model	POWER + SNT2100
Category	Snow Blower
Language	English