Why is my EGO SNT2100 Snow Blower not starting?
If your EGO Snow Blower isn't starting, it could be due to a low battery charge or not pressing the safety button correctly. Ensure the battery is fully charged. Then, press the safety button and squeeze the bail switch to start the snow blower.
What to do if my EGO Snow Blower leaves a layer of snow on the ground?
If your EGO Snow Blower leaves a layer of snow on the ground after passing, the scraper bar might be worn. Consider replacing the scraper bar.
Why is the auger not turning on my EGO SNT2100?
If the motor of your EGO Snow Blower is running, but the auger isn't turning, it's possible that the drive belt is worn or broken. Replacing the drive belt may resolve this issue.
What to do if my EGO SNT2100 leaves a layer of snow?
If your EGO Snow Blower leaves a layer of snow on the ground after passing, it's likely that the scraper bar is worn and needs replacing.
Explains danger, warning, or caution symbols and their purpose.
Details the mandatory need for wearing safety goggles or glasses.
Describes various safety symbols and their respective implications.
Covers safe surface use, keeping children away, dress code, and handling precautions.
Covers general safety during operation, like avoiding moving parts and slopes.
Covers charging, attaching, and detaching battery packs safely.
Detailed steps for safely operating the power controls.
Safe method for removing obstructions from the discharge chute.
Step-by-step guide to replace the scraper bar.
Procedure for replacing worn rubber paddles.
Instructions for replacing the drive belt.
General| Power Source | Battery |
|---|---|
| Clearing Width | 21 inches |
| Run Time | Up to 45 minutes (with two 5.0 Ah batteries) |
| Throw Distance | Up to 35 feet |
| LED Headlights | Yes |
| Variable Speed Auger | Yes |
| Battery Voltage | 56V |
| Auger Material | Steel |
| Warranty | 5-year limited warranty |
| Intake Height | 13 inches |
| Battery Amp-Hour | 5.0 Ah |
| Chute Control | Remote Chute Adjustment |
To Next Page
