Why is my EGO Saw bar and chain running hot and smoking?
If the bar and chain of your EGO Saw are running hot and smoking, it could be due to several reasons: * The chain tension might be too tight: remove the battery pack and re-tension the saw chain. * The chain oil tank might be empty: refill it with bar and chain lubricant. * There might be debris in the guide bar groove: clear the debris.
What to do if EGO PSA1000 Pole Saw motor runs, but chain does not rotate?
If the motor of your EGO Pole Saw runs but the chain doesn't rotate, the chain might not be engaging the drive sprocket. To fix this, remove the battery pack and reinstall the chain, ensuring that the drive links are fully seated on the sprocket.
Why EGO Chainsaw motor runs, but chain does not rotate?
If the motor of your EGO Chainsaw runs, but the chain doesn't rotate, it's likely that the chain does not engage the drive sprocket. To resolve this, remove the battery pack and reinstall the chain, ensuring that the drive links on the chain are fully seated on the sprocket.
Emphasizes wearing safety goggles or glasses with side shields and a full face shield.
Warning about operating near electrical power lines to prevent electrocution.
Instructions on how to connect the pole saw attachment to the EGO Power Head PH1400.
Instructions on how to fill the oil tank with lubricant before operation.
Steps to prepare the pole saw for cutting, including checking chain tension and lubrication.
Step-by-step guide on how to perform basic cutting with the pole saw attachment.
Detailed instructions and precautions for limbing and pruning branches with the pole saw.
Step-by-step guide on how to disassemble and remove the worn bar and chain.
Procedure for adjusting the chain tension for both cold and warm conditions.
Guidance on chain maintenance, sharpening, and inspecting the drive sprocket.
Detailed steps and angles for sharpening the saw chain cutters using appropriate tools.
General| Power Source | Battery |
|---|---|
| Battery Voltage | 56 V |
| Motor Type | Brushless |
| Extension Pole | Yes |
| Bar Length | 10 in (25 cm) |
| Chain Gauge | 0.043 in (1.1 mm) |
| Chain Pitch | 3/8 in (9.5 mm) |
To Next Page
