EGO SNT2110 - Page 30

56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2110/SNT2110-FC 29
2. Use needle nose pliers (not included)
to remove the spring from the
hook to release the belt tension
(Fig. 29 & 30).
3. Remove the drive belt by
slowly turning the auger pulley
counterclockwise while pulling the
belt outwards (Fig. 31).
4. Install the new drive belt, rotating it
onto the pulleys (Fig. 32).
Tips: Rotate the new drive belt rst
around the engine pulley, then the idle
pulley, and nally around the auger pulley.
Slowly turn the auger pulley clockwise to
drive the belt inwards (Fig. 28).
5. Use needle nose pliers to install the
spring onto the hook to tension the
drive belt (Fig. 29).
6. Reinstall the drive belt cover with the
8 Torx screws removed in step 1
(Fig. 27).
31
30
32
29
Needle Nose Pliers
28
Auger Pulley
Idler Pulley
Spring
Engine
Pulley
Drive Belt
Hook