EGOFIT WALKER PLUS - Maintenance; Troubleshooting

MAINTENANCE
31
32
WARNING: Always unplug the treadmill before cleaning or maintance.
General cleaning will greatly prolong the treadmill.
Keep treadmill clean by dusting regularly. Be sure to clean the
exposed part of the deck on either side of the walking belt and also the
side rails. Keep the running shoes clean to avoid foreign material
underneath the walking belt
WARNING: Always unplug the treadmill before removing motor cover.
Make sure to removing the motor cover and clean the motor one time
per year.
Running belt and deck lubrication oil
This treadmill is equipped with a pre-lubricated, low maintenance deck system. The belt/ deck
friction may play a major role in the function and life of your treadmill, thus requiring periodic
lubrication. We recommend a periodic inspection of the deck. You need contact with our service
center if you find the damage of the deck.
We recommend lubrication of the deck according to the following timetable:
Ø Light user (less than 3 hours/ week) - Annually
Ø Medium user (3-5 hours/ week) - Every six months
Ø Heavy user (more than 5 hours/ week) - every three months
NOTE: Only use "Silicone Oil" lubricants for this equipment. In addition, do not add any other
oil ingredient; otherwise, the treadmill will be damaged. Do not over-lubricate the walking board.
Excess lubricant should be wiped off with a clean towel. We recommend that you buy the
lubrication from our distributor or directly from us.
!
!
WARNING
Any repair needs the
professional technician
!
PROBLEM
POSSIBLE
CAUSE
CHECKING CORRECTION
E01
Abnormal communication
between the lower
controller and the console
after powering on.
T
he console cables are not
connected well
.
Connect the console cables properly.
No signal output from the console.
Change the console.
No signal output from the lower
controller.
Change the lower controller.
E02
Lower controller can’t
detect the voltage of motor.
T
he motor cables are not
connected well
.
Connect the motor cables properly.
No voltage output or abnormal
voltage output from the lower
control to the motor.
Change the lower controller.
Motor
is out of order. Change the motor.
E03
Lower control can’t detect
speed signal.
PWM drive circuit failure of
lower control
Change the lower controller.
E04
Overvoltage protection.
The load of the treadmill exceeds
the rated working voltage of the
motor.
The load on the treadmill must be
within the rated operational voltage.
The treadmill motor works
abnormally.
Change the motor.
Detecting failure from the lower
controller to the motor overvoltage.
Change the lower controller.
E05
Overcurrent protection
The load of the treadmill exceeds
the rated working current of the
motor.
The load on the treadmill must be
within the rated operational current.
Wrong assembly of the motor
causes the resistance or blocking
of the motor.
Check if the assembly of motor is
correct.
Failure of lower control limiting
current system.
Change the lower controller.
E06
Driving power supply
voltage is too low.
Voltage output is too low.
Check the power supply line is normal.
The lower controller can not
detects the signal of the circuit.
Change the lower controller.
TROUBLESHOOTING