23
English
‧ If they are not being used, always disconnect all devices in the aquar-
ium from the power supply before you install/remove any parts and
before all cleaning and maintenance work.
‧ Protect the mains socket and mains plug against moisture
and wetness. A drip loop must be formed with the mains
cable. This prevents any water running along the cable to
the mains socket, which would result in a short-circuit.
‧ The electrical data of the power supply must match the data of the
power mains. This data is found on the type plate, the packaging and
in these instructions.
‧ Use only the AC/DC adapter supplied with the automatic feeder. If it is
to be used as a spare part, you must specify the EHEIM order num-
ber 7341218 (for USA only 7341248) for replacement.
Commissioning
Installing the automatic feeder (⌦A/B)
1. Connect the drum unit
to the drive unit
.
2. Connect the plug
of the switching power supply unit to the socket
at the underside of the drive unit.
Installing the automatic feeder – aquariums with covers (⌦C)
‧ In order to prevent the feed from clumping due to the damp air being blown in, the automatic feeder must not
be installed underneath the aquarium cover.
‧ Use a at part of the aquarium cover to install the automatic feeder; this will ensure that the feed can easily
reach the water’s surface.
To Next Page
Loading...
