24
English
1. Remove the protective lm of the adhesive securing point
.
2. Place the automatic feeder on the aquarium cover.
Installing the automatic feeder – open aquariums (⌦D/E)
1. Fasten the terminal
by turning the plastic nut
on the pool edge of the aquarium.
2. Place the plate
in the correct position on the terminal.
3. Remove the protective lm of the adhesive securing point
.
4. Place the automatic feeder on the plate.
Filling the feed drum (⌦F)
1. Remove the drum unit from the drive unit.
2. Remove the cover
from the feed drum
.
3. Fill the feed drum with feed up to the max marking.
Only use standard ake food or feed granulate. The following feed types must never be used: Large akes, sticks,
feed tablets, frozen and wet feed or live feed.
4. Put the cover back.
5. Reconnect the drum unit to the drive unit.
Operation with WLAN connection
System requirement
WLAN-enabled terminal device (smartphone, tablet, notebook etc.)
Creating the network
1. Insert the switching power supply unit in the mains socket. The status LED
in the touch eld
illuminates.
‧ The status LED ashes white: The network is being searched for or created
‧ The status LED illuminates blue: A new network has been created (master mode)