•
Only carry out the activities that are described in these instructions.
•
Never make technical alterations to the device.
•
Use only original spare parts and accessories for the device.
•
Immediately disconnect all equipment in the aquarium from the mains
supply following a water leak or the tripping of the residual current pro-
tection device.
•
Always disconnect all equipment in the aquarium from the mains supply
when it is not in use, before you install and / or remove equipment and
before all cleaning and maintenance work.
•
The device must not be placed on or inside the aquarium cover.
•
The electrical data of the device must correspond to the data of the
mains supply. This data can be found on the rating plate, on the packa-
ging or in these instructions.
The device is operated in connection with EHEIM powerLED+ lamps. Refer to
the operating manual of the lamp, in particular the chapter about safety, start-
up, service and maintenance!
Danger! Electric Shock!
Do not place the device on or in the aquarium cover!
4. Installation
To Next Page
Loading...
Need help?
General
