EHEIM Professionel 4e+ 350 - Safety Instructions and Operation; Terminology of Display; Connecting and Initial Operation; Flow Rate Adjustment

E
nglish
Safety instructions
FOR HOUSEHOLD USE ONLY! WARNING! RISK OF ELECTRIC SHOCK! This pump has not been investigated for
use in swimmung pools areas! DO NOT RUN DRY!
Danger! Prior to carrying out works in the water, disconnect all electronic devices installed in the water from
the mains. Assure that no water intrudes into the filter’s plug connections.
The device’s power supply line cannot be replaced. In case of cable damage, the device must no longer be
operated. Contact your specialist dealer or an EHEIM service center or visit www.eheim.com

Service / programming

Flowrate plus

Flowrate minus

Warning indicator

Output max

Automatic mode
off / programming

Service indicator

Flowrate indicator.
S
1. Terminology of display
Set the locking lever to „ON“. Rapidly press the suction aid several times consecutively until the filter tank automatically
fills with water.
Plug in the power supply unit at the pump head. Plug in the power cable. The filter starts the automatic self-bleeding
process (auto air out). This may take several minutes.
To accelerate the self-bleeding process, press the suction aid several times. The filter starts the automatic self-calibration
process (auto calibration).
2. How to connect and put into operation
A Flow rate reduction:
Caution:
Do not adjust the flow rate via the adapter’s gate valve!
Automatic mode (factory setting) = 6 green LEDs

are illuminated.
Shortly press the „–“ button

. One LED

is extinguished per each pushbutton stroke.
Minimum flow rate: 1 green LED

is illuminated.
B Flow rate increase:
Shortly press the „+“ button

. The orange LED

is illuminated.
Maximum flow rate. The pump no longer automatically re-adjusts itself.
3. Reducing / increasing the FLOW RATE
6
Automatic mode: 1 to 6 green LEDs

are illuminated (Fig.: factory settings).
Shortly press the „S“ button

once. Only the red LED

is illuminated.
The indicator counts. Per each green LED = 1 month remains until the next cleaning with constant pollution increase.
After 10 seconds, the indicator automatically returns to the automatic mode. 1 to 6 LED’s

are illuminated.
4. Service display
A Activation of 12 hour bio function:
Adjust the flowrate of the SECOND 12 hours (see chapter 3A/3B).
5. Switching on / off the 12-HOUR BIO-FUNCTION