EHEIM streamON+ 6500 - Model-Specific Maintenance; Troubleshooting and Fault Clearing; Common Faults and Remedies

English
28
2. Pull the impeller j out of the motor housing.
3. Gently press the power controller f apart and remove it from the
pump basket.
4. Using a brush, clean all components under running water. Remove lime
scale deposits with 10 % citric acid
5. Install the pump again in reverse order.
When assembling, make sure that the washer disc i is correctly inserted
into the motor housing.
streamON+ 6500 / 9500 (⌦G)
1. Press both latches simultaneously and remove the pump basket h
from the motor housing.
2. Pull the power controller g out of the motor housing.
3. Pull the impeller j out of the motor housing.
4. Using a brush, clean all components under running water. Remove lime
scale deposits with 10 % citric acid
5. Install the pump again in reverse order.
When assembling, make sure that the bearing bushings k are inserted
correctly in the pump basket and in the motor housing.
7. Clearing faults
Attention! Electrocution!
▶ Before clearing faults, remove the mains plug of the pump.
Faults Possible cause Remedy
Pump does not start No mains voltage ▶ Check the mains
voltage
▶ Check the supply line
Pump does not pump Mains plug is not inserted ▶ Insert the mains plug in
the mains socket
Impeller is blocked ▶ Clean the pump