5HVHWWKHKRXVHFRGH
Sometimes in order to resolve an RF communication issue, e.g. Alarms had to be relocated, it
may necessary to reset and house code the system again.
To reset the Ei450 i-controller press and hold the house code
switch. All segments will flash blue briefly and then go solid.
After 5 seconds approx. the segments will start flashing blue.
At this point release the house code switch. The Ei450 has
now been reset.
To reset the other Alarms and accessories in the system
consult the appropriate instruction manuals.
Fire / CO Alarm Controller
MODE
POWER H.CODE
OFFON
12
To Next Page
Loading...