12.3.2. Alarm Memory function
If there has been an alarm condition in the last 24 hours the red LED will flash
twice every 16 seconds. An alarm condition outside of the previous 24 hours
can be checked by pressing and holding the test button, the red LED will flash
every 0.5 seconds and the sounder will chirp rapidly.
12.3.3. Identifying faulty Alarms
To indentify a beeping Alarm in your system, press and hold the test button
of each Alarm. In the faulty Alarm the yellow LED will flash rapidly to indicate
a smoke chamber fault. In the case of a low battery fault, the yellow LED
will flash rapidly and the Alarm will ramp to full sound. For either of these
conditions the Alarm should be replaced.
12.4. AudioLINK
AudioLINK is an added feature available in the EIB650i series only. This
feature allows an authorised person to download information from the Alarm
through the use of a mobile App. For more information on using this feature,
please refer to the relevant section on www.eielectronics.com.
36
To Next Page
Loading...
