To Next PageTo Next Page
Need help?Do you have a question about the Ei Electronics Ei650 Series and is the answer not in the manual?
General| Sensor Type | Optical |
|---|---|
| Alarm Sound Level | 85 dB at 3 meters |
| Operating Temperature | 0°C to 40°C |
| Silence Function | Yes |
| Standards Compliance | EN 14604:2005 |
| Warranty | 5 years |
| Humidity Range | 15% to 95% non-condensing |
Guidelines for optimal smoke alarm placement for effective fire detection.
Instructions for mounting smoke alarms on ceilings, including specific spacing.
Areas where smoke alarms should not be installed to prevent nuisance alarms.
Step-by-step guide for physically installing the smoke alarm unit.
Method to prevent unauthorized removal of the smoke alarm from its mounting.
Instructions for connecting multiple alarms using hardwired cables for unified alarms.
Steps to manually test the smoke alarm's functionality and sounder.
How to silence nuisance alarms and address false alarms.
Conditions and procedure for replacing the smoke alarm unit due to age or fault.
Essential safety measures and advice for using smoke alarms effectively.
Guidance on planning escape routes in case of a fire.
Explains circumstances where smoke alarms may be ineffective or fail.
Describes the function of the RadioLINK module for wireless interconnection.
Addresses common causes for alarms sounding without apparent reason.
Explains why an alarm might fail to sound during a test.
Table detailing LED and sounder indications for different alarm modes.
Table detailing LED and sounder indications for Ei650i alarm modes.
Explains advanced diagnostic modes for identifying faults and predicting issues.
Instructions for physically installing the RadioLINK+ module into compatible alarms.
Steps for coding the module and alarms for wireless system communication.
Procedure to reset the module and system to factory settings for troubleshooting.
Allows adding new alarms to an existing RF system wirelessly.
Function to monitor RF signal path, strength, and system tampering.
Capability to extract event log information from alarms via a download device.
Guidelines and procedures for testing the interconnected RF alarm system.
How to check the battery status of the module and associated alarms.
Addresses problems with RF signal path and inter-alarm communication.
Details the five-year warranty for the RadioLINK+ module.
