12
Correctly using the device
The high-pressure cleaner must be set upright
on a level, stable surface.
It is recommended that you maintain the correct
operating position every time you use the machi-
ne by placing one hand on the pistol and the
other on the lance.
Never direct the water jet toward electrical lines
or the machine itself.
It is normal for the pump to leak a little; this is
necessary to avoid damage to the pump when it
is at a standstill.
Maintenance
Checking the water intake filter (Fig. 5)
Periodically check the intake filter in order to prevent
clogging, which could jeopardize operation of the
pump.
To do this, unscrew the connection coupling for the
water inlet hose from the device and clean the expo-
sed inlet sieve by placing it under running water.
Long periods of nonuse (electric pump)
If the machine is going to be stored for longer peri-
ods of time (i.e. over three months) in a room where
frost could develop, it is recommended that the
machine be filled with an antifreeze solution (similar
to the antifreeze solutions used for vehicles).
When the device is not used for an extended period
of time, lime deposits begin to form in the electric
pump, which in turn can lead to starting difficulties.
Electric motor
The electric motor is equipped with a motor circuit
breaker switch. When the motor starts to run hot, it is
cut out by this switch. Switch off the machine. Wait 5
- 10 minutes before using the device again. Try to
determine the cause of the fault. If the problem
repeats itself, please contact a customer service cen-
ter.
Technical data
Rated voltage 230 V ~ 50 Hz
Power rating 1500 watts
Working pressure 95 bar
System pressure (EW bar) max. 130 bar
Output 400 l/h
Suction height 1 m
Max. water inlet pressure 7 bar
L
pA
sound pressure level 71,8 dB (A)
L
WA
sound power level 85,3 dB (A)
Weight 17 kg
Ordering replacement parts
Please quote the following data when ordering repla-
cement parts:
앬 Type of machine
앬 Article number of the machine
앬 Identification number of the machine
앬 Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
GB
To Next Page
Loading...
Need help?
General