Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place, so that the information is available at
all times. If you give the equipment to any other
person, hand over these operating instructions and
safety regulations as well. We cannot accept any
liability for damage or accidents which arise due to a
failure to follow these instructions and the safety
instructions.
1. Safety regulations
The corresponding safety information can be found
in the enclosed booklet.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1 / 2)
1 ON/OFF switch
2 Locking lever for angle and height adjustment
3 Setting wheel for cutting depth
4 Additional handle
5 Adapter for dust extraction system
6 Dust bag
7 Face spanner
8 Locking knob for changing the cutter
9 Base plate
10 Angle stop
11 Drive motor
3. Items supplied
앬 BT-BJ 900
앬 Case
앬 Adapter for dust extraction system
앬 Dust bag
앬 Face spanner
4. Technical data:
Voltage: 230 V ~ 50 Hz
Power rating: 860 watts
Idling speed: 11,000 rpm
Cutter dimensions: ø 100 x ø 22 x 3,8 mm
Cutting depth: max. 14 mm
Angle settings: 45°/90°/135°
Protection class: II / 쓑
Weight: 3.01 kg
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L
pA
sound pressure level 88 dB(A)
K
pA
uncertainty 3 dB
L
WA
sound power level 102 dB(A)
K
WA
uncertainty 3 dB
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three
directions) determined in accordance with EN
60745.
1. Handle
Vibration emission value a
h
= 1,59 m/s
2
2. Additional handle
Vibration emission value a
h
= 0,943 m/s
2
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.
5. Proper use
The biscuit jointer is designed for cutting slots for
biscuit joints in solid wood, plywood and
particleboard.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
10
GB
To Next Page
Loading...
