Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety information
Please refer to the booklet included in delivery for the
safety instructions.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Proper use
The equipment is designed for the grinding/sanding
of wood, iron, plastic and similar materials using the
appropriate grinding/sanding paper.
The eccentric grinder/sander is not suitable for wet
grinding/sanding.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
3. Layout (Fig. 1)
1 Sanding/grinding disk
2 Handle
3 Locking knob
4 Control switch
5 Dust bag connector
6 Dust bag
7 Setting the rotational speed
8 Additional handle
4. Technical data
Voltage 230 Volt ~ 50 Hz
Power input 420 W
Grinding/sanding area Ø 125 mm
Abrasive paper size Ø 125 mm
Vibrations per minute 6000-12,000
Totally insulated II/쏾
Weight: 2.2 kg
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L
pA
sound pressure level 84,4 dB(A)
K
pA
uncertainty 3 dB
L
WA
sound power level 94,4 dB(A)
K
WA
uncertainty 3 dB
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Additional handle
Vibration emission value a
h
= 10,462 m/s
2
K uncertainty = 1,5 m/s
2
Handle
Vibration emission value a
h
= 6,712 m/s
2
K uncertainty = 1,5 m/s
2
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.
8
GB
To Next Page
Loading...
