GB
9
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual of the
base frame and of your tool with due care. Keep this
manual in a safe place, so that the information is
available at all times. If you give the equipment to
any other person, give them these operating
instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety information
Please refer to the information included in delivery
with your electrical tool (for example RT-XM 305 and
RT-SM 430) for its safety instructions.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
1.1 Instructions for the base frame
The machine must be set up where it can stand
safely. Make sure that the ground in your work-
place is tidy, even and strong.
Make sure the saw is fixed securely on the base
frame.
Keep children away from the machine when it is
connected to the power supply
Do not let visitors contact tool or extension cord.
All visitors should be kept away from work area.
Store idle tools. When not in use, tools should be
stored in dry, high or locked up places, out of the
reach of children.
It is imperative to observe the accident prevention
regulations in force in your areas as well as all
other generally recognized rules of safety.
2. Layout
Base frame (Fig. 1-3)
A. Support feet
B. Side part
C. Intermediate strut
D. Corner reinforcement
E. Bottom cross struts
F. Top cross struts
J. Saw mount (for RT-SM 430 only)
3. Supplied package (Fig. 1-3)
4x Support feet (A)
2x Side parts (B)
2 x Intermediate struts (C)
4 x Corner reinforcements (D)
2 x Bottom cross struts (E)
2 x Top cross struts (F)
4 x Nuts (G)
4 x Washers (H)
36 x Nuts (I)
4 x Saw mount (J)
36 x Washers (K)
36 x Screws (L)
4 x Allen screws (M)
4 x Screws (N)
4x Washers (Q)
4x Cap nuts (R)
4x Screws (S)
4. Proper use
This base frame is designed as base for the mitre
saw RT-XM 305 and RT-SM 430.
The item is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
Sawing machines are to be operated only with
suitable saw blades. It is prohibited to use any type
of cutting-off wheel.
To use the machine properly you must also observe
the safety regulations, the assembly instructions and
To Next Page
Loading...