To Next PageTo Next PageWhat to do if EINHELL GC-WW 8042 ECO Water System motor fails to start up?
If the motor of your EINHELL Water System fails to start, there are a couple of things you can check. First, ensure that there is mains voltage present; check the voltage. Second, the pump rotor might be blocked; in this case, dismantle and clean the pump.
Why EINHELL GC-WW 8042 ECO has no intake?
The EINHELL Water System might not be drawing water due to several reasons. The intake valve may not be immersed in water; ensure it is fully submerged. The pump chamber might lack a water connection, so fill water into the intake. Air could be present in the intake line, so ensure the intake line is airtight. The intake valve could be leaking, so clean it. The strainer on the intake valve might be blocked, so clean the strainer. Finally, the suction height may be exceeded, so check the suction height.
Why EINHELL GC-WW 8042 ECO Water System has inadequate delivery rate?
An inadequate delivery rate in your EINHELL Water System can stem from several causes. The suction height might be too high, so check it. The strainer could be dirty, so clean the strainer. The water level might be falling rapidly, so immerse the intake valve deeper. Contaminants might have diminished the pump's performance, so clean the pump and replace any worn parts.
What to do if thermostat switches EINHELL Water System pump off?
If the thermostat is switching off your EINHELL Water System pump, it could be due to a motor overload, so dismantle and clean the pump. Alternatively, friction caused by foreign substances might be too high, so prevent the intake of foreign substances by using a filter.
General| Power | 800 W |
|---|---|
| Suction Height | 8 m |
| Max Water Temperature | 35 °C |
| Tank Volume | 20 L |
| Pressure Switch | Yes |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Housing Material | Plastic |
| Impeller Material | Plastic |
| Max Flow Rate | 42 l/min |
| Connection Diameter | 33.3 mm |
| Suction Connection | 33.3 mm (R1 AG) |
| Pressure Connection | 33.3 mm (R1 AG) |
