GB
- 26 -
9. Troubleshooting guide
Fault Possible causes Remedy
The motor does not
start
- Engine start/stop lever not activated
- Spark plug defective
- Fuel tank empty
- Press the engine start/stop lever
- Replace spark plug
- Top up fuel
Engine does not run
smoothly
- Air fi lter dirty
- Spark plug worn
- Clean the air fi lter
- Clean/Replace the spark plug
The equipment
does not operate
smoothly and vibra-
tes intensively
- Cutting unit/aerator roller imbalan-
ced
- Replace the cutting unit/aerator rol-
ler
Motor is running,
roller is not rotating
- V-belt torn - Have the V-belt replaced by a cus-
tomer service workshop.
The reprinting or reproduction by any other means, in whole or in part, of documentation and papers
accompanying products is permitted only with the express consent of the iSC GmbH.
Subject to technical changes
Anl_GE_SA_1335_P_SPK7.indb 26Anl_GE_SA_1335_P_SPK7.indb 26 16.09.2016 09:36:2116.09.2016 09:36:21
To Next Page
Loading...
