GB
22
Troubleshooting
Please read the safety information on page 8 and 9.
Fault Cause Remedy
Motor does not run No electricity Check socket, cable and plug.
Chain brake Damaged cable: Have repaired by
Customer Service. It is prohibited to patch
the cable with insulating tape.
Damaged switches have to be replaced
by a Customer Service workshop.
See section 16 and 17 „Chain brake“ and
„Releasing the chain brake“.
Chain does not move Chain brake Check the chain brake, release if
necessary.
Poor cutting performance Blunt chain Sharpen the chain
Chain wrongly fitted Check that the chain is fitted correctly
Chain tension Check the chain tension
Saw works only with difficulty Chain tension Check the chain tension
Chain jumps off sword
Chain becomes hot Chain lubrication Check oil level
Check chain lubrication
Never use tools with defective On/Off switches.
In the case of all other types of technical faults, please contact an authorized Customer Service workshop, our
Central Service Department, or your local dealer.
Anleitung KSE 2000-1_SPK1:Anleitung KSE 2000-1 12spr 15.01.2007 11:22 Uhr Seite 22
To Next Page
Loading...
