EINHELL TC-LD 50 Operating Instructions

GB
- 22 -
measurement
→ The result is displayed at the bottom in m
6.6 Deleting values (Fig. 3 / Item 4)
To delete any wrongly measured values again,
press button C briefl y. You can then perform the
measurement again.
6.7 Memory (Fig. 3 / Item 4 D, E, C)
The last 20 measured values are automatically
saved in the memory. To enter the memory, press
button D (+) or E (-). You can also use these but-
tons to search the memory. To delete the saved
values, press button C.
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.3 Ordering spare parts and accessories
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
Tip! For good results we
recommend high-quality ac-
cessories from
!
www.kwb.eu
welcome@kwb.eu
8. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
Disposing of batteries:
Batteries contain materials that are potentially
harmful to the environment. Never place batteries
in your household refuse, in fi re or in water. Bat-
teries should be collected, recycled or disposed
of by environment-friendly means. Send your
old batteries to iSC GmbH, Eschenstrasse 6 in
D-94405 Landau. You can then be sure that the
equipment will be correctly disposed of by the
manufacturer.
Anl_TC_LD_50_SPK9.indb 22Anl_TC_LD_50_SPK9.indb 22 22.04.2021 09:47:3322.04.2021 09:47:33

EINHELL TC-LD 50 Specifications

General

Type	Laser distance meter
Display type	Digital
Product color	Black, Red
Distance measuring units	m
Wavelength	635 nm
Laser class	2
Maximum measurement distance	50 m
Minimum measurement distance	0.05 m
Battery type	AAA
Auto power off	Yes
Battery voltage	1.5 V
Auto power off after	3 min

Weight and Dimensions

Weight	120 g
Package depth	67.8 mm
Package width	113 mm
Package height	200 mm
Package weight	310 g