To Next PageTo Next Page
Need help?Do you have a question about the EINHELL TC-SP 204 and is the answer not in the manual?
General| Power | 1500 W |
|---|---|
| Feed rate | 6 m/min |
| Idle speed | 9000 RPM |
| Dust extraction | Yes |
| AC input voltage | 230-240 V |
| AC input frequency | 50 Hz |
| Planning width (max) | 204 mm |
| Dust adapter diameter | 100 mm |
| Thickness opening (max) | 120 mm |
| Parallel guide tilt angle (max) | 45 ° |
| Surface planing material removal (max) | 3 mm |
| Thickness planing material removal (max) | 2 mm |
Weight and Dimensions| Weight | 27200 g |
|---|---|
| Package depth | 850 mm |
| Package width | 425 mm |
| Package height | 465 mm |
| Package weight | 31150 g |
| Feed table dimensions (W x D) | 370 x 210 mm |
| Thicknessing table dimensions (W x D) | 270 x 210 mm |
Essential safety rules for preventing injuries and equipment damage during operation.
Detailed list of all parts of the machine with corresponding figure references.
Defines the machine's purpose and specifies limitations for safe operation.
Key technical details, power ratings, dimensions, and performance metrics.
Warnings regarding potential hazards even when used correctly.
Critical checks and preparations required before first use or restart.
Instructions for attaching the rubber feet to the device.
Instructions for mounting the cutter guard.
Steps for installing the parallel fence.
Detailed instructions for performing planing tasks.
Detailed instructions for performing thickness planing tasks.
Detailed procedure for safely replacing the planer knives.
Guidance on identifying and resolving common operational problems.
Steps for cleaning the machine to maintain its condition.
Recommended maintenance tasks and their frequency.
Recommendations for storing the machine when not in use.
Guidance on proper disposal and recycling of the equipment.
