3
The conversion is only possible for the ekey home nger scanner integra including its control panel.
It is not possible to replace the ekey nger scanner arte.
It is recommended to have the conversion carried out by specialist personnel.
In addition to the ekey home nger scanner integra, the cable transfer may also have to be removed so that you can
get to the control panel.
If the micro control panel is installed on the lock side, the complete multi-point lock must be removed and reinstalled,
which is labor-intensive and time-consuming.
There are two sets, which dier in the dierent adapter cables depending on the installed control panel (CP IN or CP
micro):
291021 ekey dLine ngerprint adapter set FS IN/CP IN
291022 ekey dLine ngerprint adapter set FS IN/CP micro
Therefore, it is important to know which control panel was in use.
Note: The ekey dLine control unit has only one relay. If an SE IN with two relays was installed, the scope of
functions will change.
YOUR FINGER. YOUR KEY.
Important information
To Next Page
Loading...
