12
FIRST TIME SETUP WITH SUBWOOFER
To connect Subwoofer and Soundbar successfully
1. Make sure to plug the Soundbar and Subwoofer into Power Socket.
Must let the soundbar and subwoofer connect first before using the soundbar.
2. The Soundbar and Subwoofer will pair automatically, once they have successfully
paired, the indicator light on your subwoofer will remain lit.
Note: if any issues pairing, press the WPS button located at the back of your
subwoofer to reset or commence pairing with soundbar again.
3. You can now commence using soundbar and press the “INPUT” button on
remote control to pick an Input source.
•• The maximum Bluetooth connection distance in an open space between the soundbar
and subwoofer should not exceed 8m.
•• To avoid sound quality interference caused by wireless signal interference, when you
are playing with the soundbar, please ensure it is kept at an appropriate distance
from other Bluetooth devices to avoid wireless signal interference.
•• The flashing blue LED on the subwoofer will turn red if the paired soundbar is turned
off, on STANDBY or not connected to the power. It is indicated that the subwoofer has
also entered into STANDBY mode.
•• If not paired successfully, disconnect the subwoofer and soundbar from each other:
1. Turn off the soundbar and subwoofer by unplugging the AC plug from the socket.
2. Wait 3 minutes before replugging the AC plug into the power socket again.
Ensure the soundbar and subwoofer are connected to the main power at the
same time.
3. Press and hold the subwoofer’s rear panel WPS button to reset the connection,
so that the soundbar and subwoofer can be reconnected again.
To Next Page
Loading...
General