EasyManuals Logo

EKO KSB212WDA User Manual

EKO KSB212WDA
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
7
REMOTE CONTROL
• The remote control has a reception range of approximately 5m. Be sure to point
the remote control directly at the sensor at the front of the soundbar.
• Make sure there are no obstacles in the way. This will intefere with the sensor strength.
• Handle the remote control carefully, please do not drop, apply shock or step on it.
• Do not spill water on it.
• Using the remote control while operating other remote controls which use infra-red
rays near the unit as this will cause it to operate incorrectly.
• If you do not intend to use the remote control for a period of a month, remove the remote
control to prevent battery leakage or corrosion.
INPUT
SELECTION
MUTE/UNMUTE
NEXT
VOLUME DOWN
INCREASE
BASS
DECREASE
BASS
DECREASE
TREBLE
INCREASE
TREBLE
VOLUME UP
PLAY / PAUSE
PREVIOUS
SONG
POWER ON
PAIRING MODE/
SURROUND SOUND
(refer to below notes)
EQ MODES
3D EQ MODE
Play/Pause, Previous and Next buttons only work in USB or Bluetooth mode.
Press and Hold Play/Pause for 2 seconds to RESET device to factory settings.
PAIR BUTTON:
LONG PRESS - Press and hold for 2 seconds to disconnect or connect last used device.
SHORT PRESS - SURROUND SOUND On/O - This will show ON or OFF on Display of the
soundbar.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EKO KSB212WDA and is the answer not in the manual?

EKO KSB212WDA Specifications

General IconGeneral
BrandEKO
ModelKSB212WDA
CategorySubwoofer
LanguageEnglish