What to do if magnetic arm cuff buckles on Ekso Bionics Industrial Equipment are not seating properly?
If the magnetic arm cuff and upper arm strap buckles on your Ekso Bionics Industrial Equipment are not seating properly, inspect the magnetic buckles for any debris. Clean the buckles with a cloth and/or compressed air to ensure proper seating.
How to clean dirty vest soft goods on Ekso Bionics EksoVest Industrial Equipment?
To address dirty or sweaty vest soft goods on your Ekso Bionics Industrial Equipment, wash them in a washing machine using laundry detergent and cold water. Tumble dry on a low-heat cycle. Ekso Bionics suggests using a mesh bag for washing and drying.
General| Brand | Ekso Bionics |
|---|---|
| Model | EksoVest |
| Category | Industrial Equipment |
| Language | English |
Specifies the manual's part number and copyright holder.
Lists registered trademarks and patent pending status.
Disclaims liability for injury or damage from improper use or unauthorized repair.
Provides company address, phone numbers, and website.
Details what is covered by the warranty and common exclusions like user error or misuse.
Guidance on how measurements should be taken for proper fitting.
Instructions and diagram for measuring hip belt circumference.
Instructions and diagram for measuring torso tube length.
Instructions and diagram for measuring arm cuff length.
Instructions and diagram for measuring arm cuff diameter.
Instructions and diagram for measuring upper arm strap circumference.
Charts correlating measurements to hip belt and torso tube sizes.
Charts correlating measurements to arm cuff and upper arm strap sizes.
Charts correlating measurements to upper arm strap sizes.
Diagram and table identifying mechanical and hardware components.
Diagram and table identifying soft goods and their kit inclusion.
Procedure for adjusting torso tube length based on measurements.
Step-by-step guide for attaching the hip belt to the vest.
Instructions for attaching the hip belt extender for increased width.
Procedure for attaching arm cuffs and upper arm straps to plates.
Explains when and why to adjust link assemblies for range of motion.
Detailed steps for adjusting link assembly positions on the torso plate.
How the switch functions when the vest is worn and ON.
How the switch functions when the vest is not worn.
Illustrates the ON and OFF positions of the switch.
Crucial safety advice regarding the high-pressure spring and ON switch.
Table showing different spring levels and their lift support.
Step-by-step guide for installing or changing actuator springs.
Safety precautions during actuator spring installation.
Describes the three activation zone settings: High, Standard, and Low.
Table detailing degree ranges for starting and max support points.
Step-by-step guide for adjusting the activation zone settings.
Safety advice to secure the arm cuff plate during zone adjustment.
Initial steps for putting on the EksoVest, including shoulder and hip belts.
Ensures the switch is OFF before donning or doffing to prevent injury.
Final steps for donning, securing arm straps, and activating the vest.
Advice on ensuring proper fit and comfort by aligning actuator tops.
Instructions for safely removing the vest in reverse order of donning.
Guidance on washing and maintaining the vest's soft goods.
Advice on checking springs, buckles, and threads for issues.
Lists components included in the vest hardware and soft goods.
Lists actuator springs and included documentation.
Lists storage bags and accessory items included with the vest.
To Next Page
