- 6 - - 7 -
Install the EK-D5 PWM G2 Motor onto the EK-
Quantum Inertia by following these steps:
1. Install the provided 60x3 O-ring gasket to the EK-D5
PWM G2 Motor.
2. Once the O-ring gasket is in place, take the pump and
place it into the EK-Quantum Inertia. You can rotate
the EK-D5 PWM G2 Motor if required.
3. Fix the pump onto the EK-Quantum Inertia using the
locking ring.
4. Take the rubber damper and place it into the pump holder.
5. Once the rubber damper is installed into the pump
holder, push the assembled part onto the EK-D5
PWM G2 Motor.
6. Take the M3x12 DIN7984 screws and secure the EK-
D5 PWM G2 Motor to the pump holder. You should
use the 2mm Allen Key. The plate with two M3 thread
holes is preinstalled by EK.
INSTALLING EK-QUANTUM
INERTIA D5 PWM D-RGB
By default, the EK-Quantum Inertia D5 PWM D-RGB
ships with a pump holder that can be installed directly
to the computer chassis. If there are no appropriate
mounting holes available, the user may need to drill
four (4) Ф5 mm holes through the metal chassis with an
electric power drill. Included is a sticker that can be
used to mark the hole centers accurately.
To Next Page
Loading...
