- 13 -
STEP1
Find an appropriate position for the unit inside (or
perhaps outside) of your computer chassis; drill
mounting holes if needed. Sticker with designated
hole positions is enclosed. Before drilling stick it to the
Computer chassis.
STEP 2
Attach the pump holder to the computer chassis using
enclosed 4 (four) M4x10 DIN7984 screws and PVC
washers. Secure the screws using enclosed 2.5mm
Allen key.
STEP 3
Insert the rubber damper into the pump holder. Insert
the EK-D5 PWM G2 Motor with attached reservoir
into the damper. Secure it using two M3x12 DIN7984
screws from the side of the holder with enclosed 2mm
Allen key. Your installation is now complete.
To Next Page
Loading...
