Using yeur dryer
7o Beginning the drying cycle
Once you have chosen all your desired settings, close the dryer door and press START(located on
the right--hand side of the control panel).
Opening the door during the operation will stop the dryer.
]b restart the dryer, dose the door and select STARTto complete the cycle.
8o Stopping your dryer
Your dryer can be stopped durk_g any stage of the d@qng process, to allow you to check on your
load or add/remove clothes.
]b do this, open the dryer door. There will be a slight dehy as the drum slows down and stops.
if the cycle is interrupted before it progresses into COOLDOWN,parts of the drum mey be hot.
Caution should be taken if removing items.
Tb start your dryer again, press START.
9oChanging cycles during operation
[f you wish to change the drying cycle you have chosen after the machine has already begun
dD4ng, press your new cycle sdecqon on the control panel.
10oFabric softener sheets
If you want to use fabric softener sheets, you must ensure that they are labeled 'dryer safe'.
Always follow the instructions on the packaging. Do not place them in a dryer with warm clothes
as there is a chance the fabric softener may stain clothes. Only use a softener sheet once, then
discard it.
11o Beeps
At the end of the cycle, the dryer will beep to let you know that the bad is finished. The drum
will automatically come to rest, allowing you to open the door and remove your load.
To Next Page
Loading...