4
3. Place the glass jug on the hotplate and make sure the lid of glass jug is fitted and
pointed to the dripping hole.
WARNING: Do not use a cracked glass jug or a glass jug with loose handle. Use the glass
jug provided only with this appliance. Be careful while handling the glass jug as it is
fragile.
4. Connect the plug into the wall outlet, press the on/off switch to the “I” position, the
light indicator will be on. The appliance will start to operate.
5. The appliance will stop from operating if the on/off switch is pressed to the “0” position
at any time. The appliance will continue to brew when the switch is pressed again to “I”
position.
Note: The coffee will stop dripping when the glass jug is removed for pouring a cup of
coffee before the entire brewing cycle is complete. Return the glass jug to the hotplate
immediately after pouring to ensure proper function of the appliance.
6. Do not open the filter or water tank cover while the coffee is brewing.
WARNING: Scalding may occur when contacting these hot surfaces during brewing
process.
7. The glass jug can be removed at anytime for serving when the brewing process is done
(about one minute after the coffee stops from dripping out).
Note: The amount of coffee collected in the glass jug will be lesser than the water you
add into the water tank, as some water is absorbed by the coffee ground. Do not contact
the hotplate while the appliance is operating as it is very hot.
8. Do not move the appliance while in use or immediately after the brewing is complete.
9. For optimum coffee taste, serve it right after brewing. To keep coffee warm for serving
later, let the appliance remain on after brewing. However, make sure to turn off the
appliance when the glass jug becomes empty.
10. Do not reheat the coffee.
11. Do not reuse the coffee ground.
12. Always switch off and unplug the plug from the wall outlet when not in use.
Caution: Be careful when pouring out the coffee from the glass jug as the temperature is
high right after brewing.
CLEANING AND MAINTENANCE
1. Unplug the appliance from wall outlet.
2. Allow the appliance to cool completely before cleaning.
3. Remove and clean the filter and glass jug after each use. Wash in warm, soapy water.
Rinse well and dry thoroughly before returning to appliance.
Caution: To protect against electric shock, do not immerse the appliance in water or any
other liquids.
4. Wipe the exterior of the product body with a soft, damp cloth to remove stains.
5. Use a damp cloth and gently wipe the hotplate. Never use abrasive cleaner to clean it.
6. Wipe body dry with a soft dish cloth.
To Next Page
Loading...