CLEANING AND MAINTENANCE
Before each operation, disconnect the appliance from the electrical mains and
allow it to cool down.
GENERAL CLEANING
Wash enameled parts with lukewarm water and detergent: do not use
abrasive products which might damage them.
Wash the flame caps and burner caps often with boiling water and detergent,
taking care to remove all deposits
The hob pan stands can also be washed in a dishwasher
For stubborn dirt, use ordinary non-abrasive detergents or specific commercial
products. We strongly advise you not to use scouring pads. Steel wool or acids
for cleaning.
HOB
Clean the hob regularly with a soft cloth wet with lukewarm water and a little
liquid detergent. Do not use the following products:
- household detergents or bleaches;
- soaped scouring pads not suitable for non-stick utensils;
- steel wool scouring pads;
- stain removers for baths or sinks.
If the hob gets very dirty, use specific commercial products.
IGNITION PLUG
Automatic burner ignition is provided (when installed) by a ceramic “plug” and
a metal electrode (B in fig.1). Periodically clean these parts of the hob
thoroughly. In addition, to avoid ignition difficulties, check that the cavities in
the burner are not obstructed.
To remove deposits from the burner cavities,
remove the cap and separate the two parts
(see diagram on the right). After cleaning,
put the two parts back together and return
them correctly to their position. After washing,
replace the hob pan stands, checking that they
are correctly positioned.
6
To Next Page
Loading...
